Sleeve seal (molded type SS/SSR)
Custom seal (machined type CS)
■Sealing device for pipe penetration position that exploits the elasticity,
stretchiness, and insulation properties of rubber
●Selection table for Sleeve seal
●Selection table for Custom seal
[Installation method] The following fixing methods are available using nuts and bolts.
Screwdriver method (SS)
For small diameters
Socket wrench method (SSR)
For medium and large diameters
A10866 Sleeve seal
Rubber molded in a
mold

Supports standard
combinations
(SS and SSR)
A17287 Custom seal
Rubber cut and machined
from rubber
sheet

Supports combinations
where a sleeve seal
does not fit (CS)

Material and heat resistance
Type Sealing rubber Plate Bolt and
nut		 Heat
resistance		 Application
Sleeve seal Custom seal
S
NT*
HT*
HTS**		 EPDM rubber
Nitrile rubber
Silicon rubber
Silicon rubber		 Neoprene rubber
Same as left
Same as left
－		 Glass fiber reinforced resin
Glass fiber reinforced resin
Heat resistant reinforced resin
SUS304		 SUS304
SUS304
SUS304
SUS304		 100℃
100℃
180℃
－		 For general use
For oil
For high temperature
Fire retarding division
* mark: Contact us in advance for NT, HT and HTS.
**HTS is a certification number PS060WL-0962 Fire Compartment Penetrating compliant
　 product certified by the Minister of Land, Infrastructure, Transport and Tourism.
104-8251 　　　1-19-2 Shintomi Chuo-ku Tokyo
Copying and reproduction are strictly prohibited(C)2017
.AKAGI CO.,LTD.